Grundfos SP Safety Instructions And Other Important Information

Declaration of conformity
UK declaration of conformity
We, Grundfos, declare under our sole responsibility that the
products to which the declaration below relates, are in conformity
with UK regulations, standards and specifications to which
conformity is declared, as listed below:
Valid for products:
Submersible pump
• Supply of Machinery (Safety) Regulations 2008
Standards used: EN 809 + A1:2009
• Electrical Equipment (Safety) Regulations 2016
Standards used: EN 60204-1:2018, EN 60335-1:2012 + A11:2014, EN 60335-2-41:2003 + A1:2004 + A2:2010
• Electromagnetic Compatibility Regulations 2016
Standards used: EN 60034-1:2010, EN 55011:2009 + A1:2010
(Applies only to motors with Tempcon sensors.)
• The Ecodesign for Energy-related Products and Energy Information Regulations 2019
Water pumps:
Regulation (EU) No 547/2012
Applies only to water pumps marked with the minimum efficiency index MEI. See pump nameplate.
• The Restriction of the Use of Certain Hazardous Substances in Electrical end Electronic Equipment Regulations 2019
Standard used: EN IEC 63000:2018
Bare shaft pump
• Supply of Machinery (Safety) Regulations 2008
Standards used: EN 809 + A1:2009
• Electrical Equipment (Safety) Regulations 2016
Standards used: EN 60204-1:2018, EN 60335-1:2012 + A11:2014, EN 60335-2-41:2003 + A1:2004 + A2:2010
• Electromagnetic Compatibility Regulations 2016
Standards used: EN 60034-1:2010, EN 55011:2009 + A1:2010
(Applies only to motors with Tempcon sensors.)
• The Ecodesign for Energy-related Products and Energy Information Regulations 2019
Water pumps:
Regulation (EU) No 547/2012
Applies only to water pumps marked with the minimum efficiency index MEI. See pump nameplate.
Before the pump is taken into operation, the complete machinery into which the pump is to be incorporated must be declared in
accordance with all relevant regulations.
• The Restriction of the Use of Certain Hazardous Substances in Electrical end Electronic Equipment Regulations 2019
Standard used: EN IEC 63000:2018
This UK declaration of conformity is only valid when accompanying Grundfos instructions.
UK Importer: Grundfos Pumps ltd. Grovebury Road, Leighton Buzzard, LU7 4TL.
Bjerringbro, 16/March/2021
Frank S. Madsen
Capability Manager, Electronics
Grundfos Holding A/S
Poul Due Jensens Vej 7
8850 Bjerringbro, Denmark
Manufacturer and person empowered to sign the UK declaration of conformity.
10000336541
121
Declaration of conformity

Grundfos SP Specifications

General

Material	Stainless Steel
Pump Type	Submersible
Application	Irrigation
Motor Range	0.37 kW to 4 kW
Liquid Temperature	0 °C to 40 °C
Series	SP
Power Range	0.37 kW to 4 kW
Frequency	50 Hz, 60 Hz
Head	Up to 200 m
Discharge Size	1 inch to 4 inches