Need help?Do you have a question about the Grundfos UPE 25-80 and is the answer not in the manual?
General| Power Supply | 1 x 230 V, 50 Hz |
|---|---|
| Pipe Connection | G 1 1/2 |
| Max. Operating Pressure | 10 bar |
| Port-to-port length | 180 mm |
| Enclosure class | IP42 |
| Insulation class | F |
| Head | 8 m |
| Temperature Range | -10 .. 110 °C |
| Material | Cast iron |
| Pump Type | Circulator |
| Power Consumption | 3 - 83 W |
Introduces the UPE Series 2000 pumps, their integrated control, and suitable applications.
Covers terminal box positions, non-return valves, air separators, and frost protection.
Safe electrical connection guidelines and the initial pump start-up process.
Explains Proportional and Constant pressure control modes and general pump features.
Covers temperature influence, curve duties, and introduction to expansion modules.
Using the pump's control panel and R100 remote for setting pump head and modes.
Details on R100 menus for pump operation, status, and installation settings.
Managing setting priorities and procedures for resetting pump fault indications.
Provides a fault finding chart and detailed technical data for the pump.
Instructions for performing electrical insulation testing on the pump.
Guidelines for environmentally sound disposal of the pump and its components.
To Next Page