75
ENGLISH
NETWORK SETUP
-------------------------------------------------------------------------------------------
Manual connection
Certain networks require Static IP address. If
your network requires a Static IP address, you
must enter the »IP Address«, »Netmask«, »Gate-
way« and »DNS« values manually. You can
get »IP Adress«, »Netmask«, »Gateway« and
»DNS« values (IPS) from your Internet Service
Provider.
1 Open the menu with »MENU«.
2 Select menu item »Settings« with »
V
«, »
Λ
«,
»
<
« or »
>
« and press »OK« to confirm.
3 Select the menu item »Network« with »
>
« or
»
<
« and press »
V
« to confirm.
– »Network« menu is active.
4 Select the line »Change Connection Type«
»
V
« or »
Λ
« and press »OK« to confirm.
5 Select the option »Wired« with »
V
« or »
Λ
«
and press »OK« to confirm.
6 Select the line »Network Configuration«
with »
V
« or »
Λ
« sand use »
<
« or »
>
« to
select »Manual«.
– »IP Address«, »DNS«, »Netmask« and
»Gateway« options are active.
Change Connection Type Wired
Network Configuration Manual
Wake-on-LAN Off
IP Address 192 . 168 . 000 . 200
DNS 192 . 168 . 000 . 254
Netmask 255 . 255 . 255 . 200
Picture
Tuesday
xx xxx xxxx
Source TimerSound NetworkTV
Settings > Network
Change AreaConnect Test Connection
Input Mode
ExitBack
EXITBACK
7 Select the line »IP Address« with »
V
«.
Enter IP address with »1…0«.
8 Select the line »DNS« with »
V
«.
Enter IP address with »1…0«.
9 Select the line »Netmask« with »
V
«
Enter Netmask address with »1…0«.
10 Select the line »Gateway« with »
V
«.
Enter Gateway address with »1…0«.
11 With »
« (red) select »Connect« option to
establish modem connection.
– »Connecting... Please wait« message will
be displayed, and if the connection is
successful, Connection to Gateway: Suc-
cessful« message will be displayed.
12 Press »
« (green) to check the performed
settings and also if the local network and
internet connection has been established.
– »Testing ... Please wait« message will
be displayed, and if the connection is
established »Connection To Gateway:
Success«, »Internet Connection: Success-
ful« message will be displayed.
13 Press »EXIT« to end the settings.
To Next Page
Loading...
Need help?
General