ENGLISH
24
CONNECTION AND PREPARATION
---------------------------------------
Connecting the loudspeakers
1 Insert the wires of the loudspeaker cable into
the »SPEAKER
OUTPUT (4 �)
R L« fasten-
ers on the hi-fi system.
Note:
7
Observe the left and right channels (L = left
channel, R = right channel).
Connecting the antenna
1 Plug the roof antenna cable into the antenna
socket »FM ANTENNA« on the hi-fi system.
Note:
7
If no roof antenna is available, use the
auxiliary antenna supplied. When suitably
positioned and with adequate signal, this
antenna provides adequate reception of
FM channels. Do not shorten the auxiliary
antenna.
Connecting an MP3 player or a
USB memory stick
Caution:
7
The hi-fi system must be switched off while
the USB connection is being made. If it is
not switched off, data can be lost.
1 Connect the USB interface of the MP3 player
to the » « socket of the hi-fi system with a
standard USB cable;
or
insert the USB plug of the USB memory stick
into the USB interface » « of the hi-fi
system.
Connecting external devices
Note:
7
Switch the hi-fi system off before you con-
nect external devices.
1 Use standard audio cables (3,5mm) to cona-
nect the audio outputs of the external device
to the »AUDIO IN« sockets on the hi-fi
system.
Connecting the power cord
Notes:
7
Check that the mains voltage on the type
plate (on the bottom of the hi-fi system)
corresponds to your local mains supply. If
this is not the case, contact your specialist
dealer.
7
All the other devices/loudspeakers must be
connected before you connect the power
cord.
1 Plug the power cord into the wall socket.
Caution:
7
The hi-fi system is connected to the mains
with the power cord. Pull out the power
plug if you want to completely disconnect
the hi-fi system from the mains.
7
Make sure the power plug is easily acces-
sible during operation and not hindered by
other objects.
To Next Page
Loading...
