Grundig CMS 1050 DAB+ - Setting the Time; Setting the Alarm

ENGLISH
28
SETTINGS
---------------------------------------------------------------------------------------------------------------------------------------
Setting the time
1 To set the time in standby mode, press and
hold »CLOCK« for about 2 seconds.
– Display: »24 HOUR«.
2 Select the hour format (12 or 24 hours) by
pressing »
3
« or »4 « and con-
firm with »CLOCK«.
– The hours flash.
3 Set the hours by pressing »
3
« or
»4 « and confirm with »CLOCK«.
– The minutes flash.
4 Set the minutes by pressing »
3
« or
»4 « and confirm with »CLOCK«.
– Display: the current time.
Notes:
7
Some RDS stations transmit an RDS time
signal. If the selected RDS station transmits
time information, the time can be updated
automatically.
Press »INFO« repeatedly until the time is
displayed. If »RDS CLK« displayed, the
time signal has not yet been received.
Please wait until the time is displayed.
7
The time must be reset after a power failure
or after disconnecting from the mains.
Setting the alarm
1 To set the alarm in standby mode, press and
hold »ALARM« for about 2 seconds.
– Display: »TIMER«.
2 The alarm programs displays; »disc«, »USB«
or »TuneR«. Press »
3
« or
»4 « and confirm with »ALARM«.
– The hours flash.
3 Set the hours by pressing »
3
« or
»4 « and confirm with »ALARM«.
– The minutes flash.
4 Set the minutes by pressing »
3
« or
»4 « and confirm with »ALARM«.
– The volume flash
5 The volume displays »VOL 12«. Select the
volume with »
3
« or »4 « and
confirm with »ALARM«.
– The volume can be selected »VOL 01« to
»VOL 31«.