EasyManuals Logo

Grundig CMS 3000 User Manual

Grundig CMS 3000
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
ENGLISH
8
CONNECTION AND PREPARATION
---------------------------------------
Connecting the loudspeakers
1 Insert the wires of the loudspeaker cable into
the »SPEAKER
OUTPUT (4 �)
R L« fasteners
on the hi-fi system.
Note:
7
Observe the left and right channels (L = left
channel, R = right channel).
Connecting the antenna
1 Plug the roof antenna cable into the antenna
socket »FM ANTENNA« on the hi-fi system.
Note:
7
If no roof antenna is available, use the aux-
iliary antenna supplied. When suitably posi-
tioned and with adequate signal, this antenna
provides adequate reception of FM channels.
Do not shorten the auxiliary antenna.
Connecting an MP3 player or a
USB memory stick
Caution:
7
The hi-fi system must be switched off while
the USB connection is being made. If it is not
switched off, data can be lost.
1 Connect the USB interface of the MP3 player
to the » « socket of the hi-fi system with a
standard USB cable;
or
insert the USB plug of the USB memory stick
into the USB interface » « of the hi-fi sys-
tem.
Connecting external devices
Note:
7
Switch the hi-fi system off before you connect
external devices.
1 Use standard audio cables (3,5mm) to cona-
nect the audio outputs of the external device to
the »AUDIO IN« sockets on the hi-fi system.
Connecting the power cord
Notes:
7
Check that the mains voltage on the type plate
(on the bottom of the hi-fi system) corresponds
to your local mains supply. If this is not the
case, contact your specialist dealer.
7
All the other devices/loudspeakers must be
connected before you connect the power cord.
1 Plug the power cord into the wall socket.
Caution:
7
The hi-fi system is connected to the mains with
the power cord. Pull out the power plug if you
want to completely disconnect the hi-fi system
from the mains.
7
Make sure the power plug is easily accessible
during operation and not hindered by other
objects.
Activating the battery in the re-
mote control
1 Open the battery compartment by pressing
down on the catch and then remove the lid.
2 Observe the polarity marked on the base of
the battery compartment when inserting the
batteries (micro batteries, 1 x 1.5 V, R 03/UM
4/AAA).
3 Close the battery compartment.
Notes:
7
Do not expose the batteries to extreme heat,
caused for example by direct sunlight, heaters
or fire.
7
Remove the batteries when they are flat or
when you know that the hi-fi system will not be
used for a long period of time. The manufac-
turer accepts no liability for damage caused
by leaking batteries.
Environmental note:
7
Batteries, including those which do not contain
heavy metal, should not be disposed of with
household waste. Always dispose of used bat-
teries in accordance with local environmental
regulations.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Grundig CMS 3000 and is the answer not in the manual?

Grundig CMS 3000 Specifications

General IconGeneral
BrandGrundig
ModelCMS 3000
CategoryStereo System
LanguageEnglish

Related product manuals