Grundig Vision 7 - Page 40

40
SPECIAL SETTINGS
------------------------------------------------------------------
Fine tuning analogue television stations
The television automatically tunes itself to the best possible recep-
tion. You may need to carry out manual fine tuning in areas where
there is poor reception.
1 Press »i« to open the »MAIN MENU«.
– The »MAIN MENU« appears.
2 Select »Channel setup« with » Λ « or » V « and confirm with »G«.
– The »CHANNEL SETUP« menu appears.
3 Select »Fine tuning« with » Λ « or » V « and set it with »
–
«
or »
+
«.
4 Select »Store« with » Λ « or » V « and confirm with »
–
« or »
+
«.
– The »Stored« message appears.
5 Press »i« to finish the setting.
Tuning the analogue television channels by
entering the channel numbers
1 Press »i« to open the »MAIN MENU«.
– The »MAIN MENU« appears.
2 Select »Channel setup« with » Λ « or » V « and confirm with »G«.
– The »CHANNEL SETUP« menu appears.
3 Select »Program no« with » Λ « or » V « and set the preset chan-
nel with »
–
« or »
+
«.
4 Select »Channel« with » Λ « or » V «.
5 Press »G« to choose between »S« (special channel) and »C«
(channel).
6 Press »
–
« or »
+
« to switch up and down channels or use
»
1…0« to enter the channel number directly.
Note:
The current system is automatically displayed in the »System« line.
Select »System« with »
Λ « or » V « if the colour or sound are in-
correct. Select the setting required with »
–
« or »
+
«.
7 Select »Store« with » Λ « or » V « and confirm with »
–
« or »
+
«.
– The »Stored« message appears.
Note:
To set the other television stations, repeat steps 3 to 7.
8 Press »i« to finish the setting.
CHANNEL SETUP
Back
Exit
Channel C 03
System BG
Fine tuning 0
Search as
Program no P01
Store
Autoprogram
CHANNEL SETUP
G
0 -
G
9
Back
Exit
Channel C 03
System BG
Fine tuning 0
Search
as
Program no P01
Store
Autoprogram
CHANNEL SETUP
G
0 -
G
9
C/S
Back
Exit
Channel C 03
System BG
Fine tuning 0
Search
as
Program no P01
Store
Autoprogram
CHANNEL SETUP
Store
Back
Exit
Channel C 03
System BG
Fine tuning 0
Search
as
Program no P01
Store
Autoprogram