GS Engineering B.V. GS 1010 - Starting the Engine

To Next Page

To Previous Page

Instruction GS 1010

GS Engineering B.V.

manufacturer hydraulic sweepers

Before the operator starts the engine, the machine must be checked

and found in good order.

Upon starting the engine, the brush drive must be turned off. First

turn off the brush, otherwise unexpected and dangerous situations

might arise.

Follow the procedure below to start the Honda GX 200:

1. Check if the brush drive is turned off. Put the sweeper switch

in neutral.

2. Put the accelerator lever in its top position indicated by the

hare. (Illustration 1)

Illustration 1

3. Use the choke. (Illustration 2)

(Illustration 2)

Closed