Gtech AirRam AR20 - Filter and Brush Bar Maintenance; Replacing the Filters; Brush Bar Jamming Identification; Brush Bar Removal Procedure

11
Slide the lter onto the inner shroud. Slide the lter and inner shroud into the
lter housing.
If the brush bar jams during use, the
AirRam will stop and the LEDs will appear
red. Before checking for a blockage,
remove the battery.
Rest the AirRam on its side and locate the
brush bar button on the right hand side.
Press the button inwards and then pull
the brush bar towards the bottom of the
AirRam.
Replacing the lters
Removing and cleaning the brush bar