17
Trimmer fails to operate 1. Recharge battery.
2. Check switch. It will click if
operating correctly.
3. Blade is jammed
Cutting blade will not cut 1. Blade is either worn or damaged.
2. Replace blade.
Blade will not move 1. Clean and lubricate blade.
2. Replace blade.
Cutting time has reduced 1. Use lighter cutting action and cut
in several stages.
2. Fully discharge and recharge
battery.
3. Clean and lubricate blade.
4. Replace blade.
Trimmer stops when cutting 1. Wait for automatic cut out to
reset. Use lighter cutting action.
2. Check blade and remove
any debris.
3. Charge battery.
LEDs show solid red 1. The hedge trimmer has jammed.
2. Check blade and remove
any debris.
If this doesn’t solve your problem don’t worry, we will help.
Go to www.gtech.co.uk or call 01905 345 891
Troubleshooting
To Next Page
Loading...
