19
There’s no latch, the bin just pulls off.
It’s easier if you wiggle it as you pull it.
Remove the lter by pulling it from the top
of the bin. Tap the dirt from the lter and tip
any dirt from the lter housing. Wash the
lter if necessary.
Hold the Multi’s bin over a rubbish bin and
release the latch to empty the dirt. A gentle
tap will help. Remove the lter and tap off the
excess debris each time you empty the bin.
Wash the lter under a tap, squeeze it out
then let it dry completely before using it.
Recommended water temperature 40°C.
Do not use detergent or soaps. (You can
buy more at www.gtech.co.uk)
Never put the bin back without the lter
inside. You could damage the motor.
Cleaning the lter
Emptying the bin
2859_System_TE_manual_update_aw.indd 19 31/05/2018 13:24
To Next Page
Loading...
