11
Remove the lter from the inner shroud,
by twisting and pulling.
Tap the inner shroud over a bin to remove
any excess dirt.
Wash the lter under a tap. Squeeze out
any excess water then let it dry completely
before reinserting into the AirRam.
Recommended water temperature 40°C.
Do not use detergent or soaps. Never put
the bin back without lter inside. You
could damage the motor.
Slide the lter onto the inner shroud. Slide the lter and inner shroud into the
lter housing.
Replacing the lters
2859_System_TE_manual_update_aw.indd 11 31/05/2018 13:24
To Next Page
Loading...
