17
Status Meaning
Standby Mower is ready to work
Mowing Mower is mowing automatically
Spot Mow Mower is mowing spirally
Returning Mower is going back to station
Charging Mower is charging
Charge to work Mower is charging and will continue program when charged
Emergency stop Mower is stopped manually
Error Mower cannot work
Firmware update Firmware is updating
Getting started:
Set the cutting height
The first cut of the season or long thick wet grass will need the highest setting (5.5cm). Gradually
reduce to desired height once all ground has been covered. This may take a few days or a few
weeks. If the perimeter wire is pegged to the surface of the garden rather than buried, it is a
good idea to let the wire “bed in” to the surface of the lawn, during which time it is advisable to
keep the mower on an elevated blade setting. NOTE during first few days of mowing the grass
may look stripy or patchy where the mower has covered /not covered. This is normal and will
become even aer several days once the full lawn area has been mowed.
First time out
The control panel will ask for a pass code. The default PIN is AAAA
Pressing the start button and closing the flap will cause the mower to start a perimeter circuit
aer which it will begin randomly mowing the lawn.
First time out
The first few mows will appear random and unfinished, this is normal. With the multiple passes
the mower makes over time, this will even out, and by using zoning and spiral spot mowing a
desirable effect can be achieved in less time. These methods are explained on page 21.
New season mowing
Between mowing seasons when the mower is not operating (during winter months) the grass
can become unkempt and thickets emerge. On new season setup review mowing pass and
address any problem areas.
4719_Robot_Mower_manual_aw3.indd 174719_Robot_Mower_manual_aw3.indd 17 20/04/2021 16:2220/04/2021 16:22
To Next Page
Loading...
