Gtech RCLM001 - Change Pin Code; Factory Reset; Error Log

23
PIN code Change PIN code
Error log
Factory reset
1. PIN code should be entered aer
powering on, pressing STOP button, and
before clearing error status and changing
PIN code.
2. If the PIN code is incorrect, the screen will
show “PIN wrong, please retry’.
3. If the PIN code is entered incorrectly 3
times, the screen will be locked for 15
seconds. The lock time will double for
further incorrect entries.
1. Press OK button to enter sub-menu 1.
2. Select ‘setting’ to enter sub-menu 2.
3. Select ‘factory reset’.
4. The screen shows ‘Reset to factory mode?’
5. Press OK button to confirm.
1. Press OK button to enter sub-menu 1.
2. Select ‘setting’ to enter sub-menu 2.
3. Select ‘change PIN’.
4. Enter the original PIN code.
5. Enter new PIN code.
6. Enter the new PIN code again. (‘New
passwords do not match’ will be shown for
inconsistent passwords.)
7. Press OK button to confirm.
1. Press OK button to enter sub-menu 1.
2. Select ‘setting’ to enter sub-menu 2.
3. Select ‘information’ to enter sub-menu 3.
4. Select ‘error log’.
5. The past 10 records (including date, time
and error message) will be shown.
In the event of malfunction the error log will
record all actions and can be used for service
maintenance and fault finding.
4719_Robot_Mower_manual_aw3.indd 234719_Robot_Mower_manual_aw3.indd 23 20/04/2021 16:2220/04/2021 16:22