Guardian 10786 - Page 8

8
Labels
English
Guardian Cross Arm Strap
Part #: Lot #:
DOM: Serial #:
Prior to use, read and understand all
manufacturer's instructions provided with
equipment at time of shipment.
Compliant with ANSI Z359.18, OSHA 1910.140,
OSHA 1926.502
Materials: Zinc-plated steel, polyester, and nylon.
Capacity Range: 100-420 lb (46-191 kg)
Type A anchorage connector.
MBS (Minimum breaking strength): 5,000 lb (22,2 kN)
Minimum service temperature: -30°F (-34°C).
All PFAS equipment must be selected and
deemed compatible with Cross Arm Strap by
a Competent Person.
Only make compatible connections. Refer to
instructions for proper connection methods.
WARNING MAXIMUM 1 connection per anchor.
Avoid contact with hazards, including, but not
limited to, heat, chemicals, electricity, and sharp
or abrasive edges and surfaces.
Inspection Grid: User must inspect prior to EACH
use. Competent Person must complete formal
inspection every 12 months. Competent Person
must inspect and initial.
Date of First Use:
Product lifetime is indefinite. as long as product
passes all inspection requirements.
If equipment fails inspection, Immediately remove
from service.
DO NOT REMOVE LABELS
Designed, Tested, and Assembled in the USA with
globally-procured materials.
90084 Rev. P
1
Prior to use, read and understand all
manufacturer’s instructions provided
with equipment at time of shipment.
Compliant with ANSI Z359.18,
OSHA 1910.140, OSHA 1926.502
Materials: Zinc-plated steel, polyester,
and nylon.
Capacity Range: 100-420 lb (46-191 kg)
Type A anchorage connector.
MBS (minimum breaking strength):
5,000 lb (22.2 kN)
Minimum service temperature: -30° F
(-34° C).
All PFAS equipment must be selected
and deemed compatible with Cross
Arm Strap by a Competent Person.
Only make compatible connections.
Refer to instructions for proper
connection methods.
MAXIMUM 1 connection per anchor.
Avoid contact with hazards, including,
but not limited to, heat, chemicals,
electricity, and sharp or abrasive edg-
es and surfaces.
INSPECTION GRID
User must inspect prior to EACH use.
Competent Person must complete
formal inspection every 12 months.
Competent Person to inspect and
initial.
Product lifetime is indefinite, as long
as product passes all inspection
requirements.
If equipment fails inspection
IMMEDIATELY REMOVE FROM SERVICE
guardianfall.com
90084 Rev. P
Designed, Tested, and Assembled in the USA
with globally-procured materials.
DOM:
XXXXXXX XXXXXXX
XXXXXXXMM/YY
Serial #:
Part #: Lot #:
Cross Arm Strap
⚠ WARNING
DO NOT REMOVE LABELS
Date: Initials:
Date of First Use:
1
90084 Rev. P
Never connect
to closed loop.
1¾”
1¼”
!
WARNING
Label Material: Scrim
90936 (Rev. A)
2
Warning
Never connect to closed loop.
90936 Rev. A
2