Guardian 10786 - Page 9

9
Inspection
Prior to EACH use, inspect Cross Arm Strap
for deficiencies, including, but not limited
to, corrosion, deformation, pits, burrs, rough
surfaces, sharp edges, cracking, rust, paint
build-up, excessive heating, alteration, broken
stitching, fraying, and missing or illegible labels.
IMMEDIATELY remove Cross Arm Strap from
service if defects or damage are found, or if
exposed to forces of fall arrest.
Ensure that applicable work area is free of all
damage, including, but not limited to, debris,
rot, rust, decay, cracking, and hazardous
materials. Ensure that work area will support the
application-specific minimum loads set forth in
this manual. Work area MUST be stable.
At least every 12 months, a Competent Person
(CP) other than the user must inspect Cross Arm
Strap.
See Inspection Log on page 10.
Inspections MUST be recorded in inspection
log in instruction manual and on equipment
inspection grid label. The CP must sign their
initials in the box corresponding to the month
and year the inspection took place.
During inspection, consider all applications and
hazards the harness has been subjected to.
Product lifetime is indefinite as long as it passes
pre-use and CP inspections.
This inspection log must be specific to one Cross
Arm Strap. Separate inspection logs must be
used for each Cross Arm Strap. All inspection
records must be made visible and available to all
users at all times. If equipment fails inspection it
must be discardedimmediately.
English
Diagram A - Connections
 
 

