Guest 2610 User Manual

5
6. TROUBLESHOOTING
Problem Cause Solution
1. Red LED stays on
for more than 24
Hrs.
1. One or more defective
or damaged cells.
2. Charger has reduced its
output voltage below
the normal level due to
a DC overload or a DC
short.
3. On-board DC systems
are drawing more
current than the charger
can replace.
1. Load test the batteries and replace
if necessary.
2. Remove the source of the overload
or short. Disconnect the charger’s
black (NEGATIVE) ring terminal
from the battery. Reapply AC
power and the green LED only
should now light.
3. Turn off all DC equipment while
charging.
2. The red and
green LED’s stay
on for more than
24 Hrs.
1. On-board DC systems
are drawing between 3
to 9A.
2. One or more defective
or damaged cells.
3. Extremely low AC
voltage at the battery
charger.
1. Turn off all DC equipment while
charging.
2. Load test the batteries and replace
if necessary.
3. Apply a higher AC voltage source
or reduce the length of the
extension cord.
3. Green LED stays
on when the
battery is known
to be low.
1. Open DC output fuse.
2. Faulty or contaminated
terminal connections.
3. One or more defective
or damaged cells.
1. Replace DC output fuse with a
Bussmann (AGX-15).
2. Clean and tighten or repair all
terminal connections.
3. Load test the batteries and replace
if necessary.
4. Neither of the
LED’s turn on
when the AC
power is applied.
1. No AC power available
at the charger.
2. Component failure
1. Connect AC power or reset the AC
breaker on the main panel.
2. Return charger to the Guest
Service Dept.

Guest 2610 Specifications

General

Brand	Guest
Model	2610
Category	Battery Charger
Language	English