GUIL - TORO lifters
www.guil-lifters.com - GUIL
-
20
Before putting the lifter into service please make sure that there is no damage caused during transportation.
Should there be any, consult your distributor or the manufacturer (GUIL
®
) and do not use the TORO lifter until
it is in prefect working condition.
The information contained in this manual is subject to change without previous notification and presents no
obligations or liability for GUIL
®
. Under no circumstances will GUIL
®
be responsible for technical or editorial
errors made here, nor for accidental or intentional, direct or indirect damages caused by following this manual
or by incomplete information in this manual. GUIL
®
will not be held responsible for any errors found in this
manual.
The information in this document is not intended to cover all possible eventualities. The user must use caution
and common sense at all times whilst using the TORO lifter. If any doubt or problem should arise do not hesitate
to contact the manufacturer GUIL
®
.
OWNER AND USER’S OBLIGATIONS
Everyone involved with the installation, operation and maintenance of this lifting tower must:
- Be sufficiently qualified, trained or experienced.
- Read and understand both the winch and the lifter manual and follow the instructions given to use them
correctly.
- Keep this manual and the winch manual for the entire service life of the product.
- Pass both manuals on to every future owner or user of the tower. This manual should be regarded as a
permanent part of your lift and should remain with the lifting tower at all times.
- If either of the manuals are misplaced please contact your dealer or the manufacturer (GUIL
®
).
SAFETY RECOMMENDATIONS
Prior to set-up, be aware of and avoid the following hazardous situations:
• Drop-offs or holes which impede the lifter being levelled using only the levelling jacks.
• Pot holes, obstacles on the floor or debris.
• Slopes that exceed the adjustment capabilities of the lifter.
• Unstable or slippery surfaces.
• Hazardous locations. Aerial obstacles or overhead electric cables.
• Inadequate surface support to withstand all load forces imposed by the lifter.
• Weather conditions and strong winds.
• The presence of unauthorised personnel.
SET-UP AND WORKING AREA SAFETY
• Do not stand under or allow personnel under the TORO lifter when the load is raised, making
sure a safety area is blocked around the tower, which should have a diameter of 1.5 times the
height of the tower.
• Do not lower the load unless the area below is clear of personnel and obstructions.
• Do not use this lifter outdoors if it is thundering and lightning or in adverse weather conditions.
Never use the TORO lifter in the event of extreme weather conditions. NOTE: Increasing the load
surface area will decrease machine stability in windy conditions.
• Never use the TORO lifter in strong or gusty wind.
To Next Page
Loading...
Need help?
General