GUIL - TORO lifters
23
www.guil-lifters.com - GUIL
-
A.- INSTALLATION WITH FRONT STABILISER LEGS
Follow the instructions below for the correct installation of the TORO lifter:
1.- Position the TORO lifter at the desired work site.
2.- Pull the stabiliser legs out of the base.
3.- Insert the legs into the front sockets with the wheels downwards, blocking them with the magnetic locking
bolts.
The stabiliser legs should be fixed at the fully extended position. If any other position is required please consult
the manufacturer (GUIL
®
).
4.- Level the lifter.
4.1.- Take the Allen key supplied out of the manual holder.
4.2.- Unblock the levelling jack by loosening the M10 bolt found on the side of the leg.
4.3.- Adjust the levelling jacks until the legs are firm and free of wobbling, levelling the lifter from the
front axis with the help of the spirit level.
To Next Page
Loading...
Need help?
General