GUIL - TORO lifters
21
www.guil-lifters.com - GUIL
-
• Avoid transporting the TORO lifter over uneven surfaces or ground with debris when in the folded position.
• Never use the lifter on moving surfaces or vehicles.
• The TORO lifter must always be set up on firm and even surfaces.
• This material lift is not electrically insulated and does not protect you if it gets close to or comes
into contact with electricity.
• If the TORO lifter comes into contact with electric cable, keep well away. The tower should not
be touched or used until the electricity has been switch off.
• Maintain safe distances away from electrical power lines and apparatus, allowing for mast
movement and electrical line sway or sag, in accordance with applicable local governmental regulations.
• Do not use the lifter as a ground for welding.
• The noise made while using this machine should not exceed 80 dB. If it were to make more noise contact your
supplier.
• Before installing the lifter, make sure the installation area can hold a minimum point load of 5 times the load
to be raised.
LIFTER USE SAFETY INSTRUCTIONS
• The installer is responsible for adhering to the load capacity specified by the manufacturer, the safety
requirements in the place of installation and the abilities and experience of co-workers.
• Do not remove the manufacturer’s labels; if removed the guarantee will be null and void.
• Always carry out a thorough inspection of your TORO lifter before each use by following the pre-operation
inspection instructions. Do not use a tower that is damaged or doesn’t work properly.
• Never use the TORO lifter with a worn, frayed, kinked or damaged winch cable.
• Do not replace parts of the TORO lifter that are critical to stability or structure with items of
different strength or specification. If it were necessary to replace components, it is important that it is replaced
with an original spare part.
• Do not exceed the rated load capacity recommended by the manufacturer GUIL
®
.
• Do not lift the load unless: the blocking hook is unhooked, all the stabiliser legs are correctly
installed and the brakes on the wheels are activated.
• Do not adjust or remove the stabiliser legs while the load is raised.
• Do not raise the TORO lifter unless the load is correctly positioned, centred and secured on the forks. The centre
of gravity should always be along a vertical line.
• Ensure the lifter is completely levelled before lifting the load.
• Never raise objects that make a large surface for the wind. If it is absolutely necessary please contact your
dealer or the manufacturer (GUIL
®
) for safety advice.
• If you are going to leave the TORO lifter unattended with a raised load make sure it can’t be
used by unauthorised personnel. Unauthorised personnel could try to use the tower without
adequate training, causing dangerous situations.
To Next Page
Loading...
Need help?
General