Guldmann GH2 F - Safety Functions, Installation;Deinstallation

16
801 Safety functions, installation/deinstallation
Installation/deinstallation
The installation/deinstallation sequence can be interrupted with the hand
control at any time:
1. Press (again) UP to interrupt the installation/deinstallation sequence
2. Press (again) DOWN to interrupt the installation/deinstallation
sequence
3. Move the switch at the bottom of the hand control back to position
to interrupt the installation/deinstallation sequence
The installation sequence will be automatically interrupted if GH2 F meets
an obstacle/resistance (≥ 5-10 kg) while being moved to the travelling trolley
in the rail system, for instance when blocked by a foreign body during
installation.
If this happens, GH2 F will stop briey and then move freely in the direction of
the travelling trolley.
Resuming installation/deinstallation
When the obstacle has been removed, the installation or deinstallation
sequence can be resumed, cf. point 6.01, “installation, step 3”.
Note
The installation/deinstallation sequence can also be interrupted with the help
of the emergency stop/emergency lowering function, or if the 24V DC plug on
the charger is connected to the hand control (point 9.0).
Activation of the emergency stop results in an interruption of the installation/
deinstallation sequence
Activation of the emergency lowering results in an interruption of the
installation/deinstallation sequence
Connection of the 24V DC plug of the charger results in an interruption of the
installation/deinstallation sequence
© Guldmann US-882/12/2011 • # 900690_1.01
© Guldmann US-882/12/2011 • # 900690_1.01
© Guldmann US-882/12/2011 • # 900690_1.01 © Guldmann US-882/12/2011 • # 900690_1.01