Guldmann GH2 F - Installation Lock

17
802 Installation lock
It is a condition for carrying out installation and deinstallation that the anchor
is attached to GH2 F. The anchor is attached/released with the help of the
push button on the top of GH2 F (1).
Important/precaution
The installation lock may only be operated/released when GH2 F has been
deinstalled and placed on a rm surface, e.g. the transport trolley for GH2 F.
The deinstallation sequence must have been completed before the installa-
tion lock is released. This means that the movement of the cord must have
stopped and the installation motor must be inactive.
Attachment to the installation lock
• Push in the button (1)
• Attach the anchor with the cord from the travelling trolley
• Release the button and check that it returns fully to its original position
Releasing the installation lock
• Wait for deinstallation to end and until GH2 F has been placed on a rm
surface, such as the transport trolley for GH2 F
• Push in the button (1)
• Release the anchor with cord from GH2 F
Place the anchor with cord at a suitable height beneath the travelling trolley.
Installation protection
There is a sensor/switch on top of GH2 F, which has a safety function (2).
The hand control will be switched off when the sensor/switch is activated.
Avoid unnecessary contact with the sensor.
Contact the Guldmann Service Team if it appears that the sensor has been
damaged.
1
2
© Guldmann US-882/12/2011 • # 900690_1.01 © Guldmann US-882/12/2011 • # 900690_1.01
© Guldmann US-882/12/2011 • # 900690_1.01
© Guldmann US-882/12/2011 • # 900690_1.01