IR Remote control
* DAC-A22 uses the new remote control, please press and hold the DAC key for more
than 3 seconds to enter the DAC operation mode. AMP and STREAM modes are used to
control other types of GUSTARD products
① Mute button: In the non-mute state, press this button once, the DAC-A22 will be muted; press this button
again to unmute.
② Menu button: Press this button once to enter the setup menu of the DAC-A22, press this button again to exit
the setting menu.
③ D-pad and OK button：After entering the setting menu of the DAC-A22, use the up/down of the D-pad to switch
the function to be adjusted, and adjust the options by left/right. Press OK to confirm the result and return
to the main page.
④ Back button: Returns to the main page state.
⑤ Volume minus button: When the DAC-A22 is in the main page state, press this button to decrease the volume.
⑥ Volume plus button: When the DAC-A22 is in the main page state, press this button to increase the volume.
Note: ● The operating distance varies depending on the angle. ● If there is something between the remote control and the IR sensor,
it may not operate normally. ● If the remote control will not be used for a long time (one month or longer), remove the battery. ● If
the battery Leaking, please thoroughly clean all the residues in the battery compartment and install new batteries. ● When using other
devices controlled by infrared rays, using this remote control may operate these devices by mistake.
To Next Page
Loading...
