6. PHASE (Phase Setting):
This function has two options:
-NON-inverted (RCA normal phase output—XLR American standard) -Default
-Inverted (RCA inverse phase output—XLR Japan/European standard)
When NON-inverted, the RCA output of X30 is normal phase, and the XLR balanced output
is American standard polarity output, that is - 1 ground, 2 hot, 3 cold.
When Inverted, not only the RCA output is reverse phase output, but the XLR balanced output will
be Japanese/European standard polarity output, that is - 1 ground, 2 cold, 3 hot.
7. TRIGGER CH. (Linkage trigger start channel selection)：
The X30 can be triggered by an external 12V linkage signal and automatically turn on from standby mode. When 30 is working,
it is switched to the input channel of this setting by the 12V trigger linkage signal.
If the 12V trigger input signal stops or turns down to 0V, it will automatically enter the standby state
Note:
***1 This time the X30 is turned on by 12V trigger, not manually turned on
***2 After this trigger, the X30 is in the trigger channel set
***3 After this trigger, the X30 input channel has not been manually switched
The above 3 conditions are met and the X30 will automatically enter standby to execute
-LAST (the input channel that was in use before entering standby last time) – Default
—COAX —AES —OPT —USB —STREAMER —IIS(G) —IIS
For the remaining channels above, whichever one you choose, when the 12V trigger signal comes,
it will enter that channel and turn on the X30.
8. TRIGGER VOL. (Link Trigger Boot Volume Selection):
X30 can be triggered by an external 12V linkage signal, and can be turned on
automatically from standby mode and set to this volume.
Or when X30 is working, it is switched to the set volume by the 12V trigger linkage signal.
This option is used to set the volume of the X30 output after the trigger power on.
- LAST (The volume used before entering standby last time) – Default
- FIXED (Output at fixed full volume)
- -20dB (Output at a volume attenuated to -20dB)
- -30dB (Output at a volume attenuated to -30dB)
- -40dB (Output at a volume attenuated to -40dB)
9. DISPLAY (Screen Brightness Settings):
-AUTO Automatically reduce brightness – Default
-AUTO OFF Automatically turn off the screen
Long-term high-brightness use of OLED screens can easily cause screen burn-in, ghosting, etc. Therefore, it is designed to always
automatically reduce the brightness, or manually select automatic screen off, which can also reduce interference.
To Next Page
