GW Instek GDM-9061 Series - Configuring the Excel Add-In

GDM-9060/9061 Series Excel Add-In Manual
10
Configuration
Configure the PC
1. To make sure the DMM is recognized by the PC,
open the Device Manager (Start  Control
Panel  (System)  Device Manager.
2. For RS232/CDC connections, check which COM
port the device is assigned to and make note of it.
3. For TMC connections, check to make sure the
DMM is recognized in the Test and Measurement
node.
Configure the
Add-In
1. From the Windows Start menu select:
Start  All Programs  GWINSTEK DMM
 GDM-906x Excel Addin  GDM-906x
Excel Addin