GW Instek GDM-9061 Series - Establish Remote Connection for Logging; Setup Multimeter for Data Logging

DATA LOGGING REMOTE CONTROL
13
DATA LOGGING
REMOTE CONTROL
Establish remote
connection
Follow the procedures for connection and
configuration on page 5 and page 10.
Setup
1. Press the Setup Multimeter icon.
2. The Set Up Multimeter window appears.
3. Choose a measurement item.
4. Choose the measurement range for DC Voltage,
DC Current, AC Voltage, AC Current, Resistance
(2W), Resistance (4W), Diode, Capacitance,
Frequency and Period.
Choose the sensor and referenceR for
TEMP-4WRTD.
Choose the sensor type and resolution for
TEMP-TC.
5. Press OK to confirm the settings and exit.
6. Press Exit to discard the settings and exit.