1. Press the Save/Load Multimeter Settings icon.
2. The Save/Load Multimeter Settings panel appears.
3. Choose to Load Multimeter Settings from File
or Save Multimeter Settings to File.
If saving a file, choose a directory and filename.
Click Save to save the file. The file will be saved as
XXXXX.DMM.
After a few moments, if the save was successful a
message “Save File OK!” will appear. Click OK.
If loading a file, choose a previously saved setup
and click Open. A message “Load File OK!” will
appear if the setup is loaded successfully. Click OK.
The panel will close automatically after
saving/loading settings.
To Next Page
Loading...
