GW Instek GDS-1000-U Series - Using the Vertical Cursors

GDS-1000-U Series User Manual
56
To move the right cursor, press
X2 and then use the Variable
knob.
X2
22.9us
0.000V
To move both cursors at once,
press X1X2 and then use the
Variable knob.
X1X2
23.6us
11.9Hz
212.0mV
Remove cursors
Press Cursor to remove the
onscreen cursors.
Cursor
Using the vertical cursors
Procedure
1. Press the Cursor key.
Cursor
2. Press X↔Y to select the
vertical (Y1&Y2) cursor.
X↔Y
3. Press Source repeatedly to
select the source channel.
Source
CH1
Range
CH1, 2, MATH
4. The cursor measurement results will appear in
the menu.
Parameters
Y1
Voltage level of the upper cursor
Y2
Voltage level of the lower cursor
Y1Y2
The difference between the upper and
lower cursor
Moving the
vertical cursors
To move the upper cursor,
press Y1 and then use the
Variable knob.
Y1
123.4mV
To move the lower cursor,
press Y2 and then use the
Variable knob.
Y2
12.9mV