Triggers on the rising edge.
Triggers on the falling edge.
Triggers only on AC component.
Triggers on AC+DC component.
Puts a high-pass filter and rejects the
frequency below 50kHz.
Puts a low-pass filter and rejects the
frequency above 50kHz.
Using the trigger level knob moves the
trigger point up or down.
Configuring the edge trigger
1. Press the Trigger menu key.
2. Press Type repeatedly to
select edge trigger.
3. Press Source repeatedly to
select the trigger source.
4. Press Mode repeatedly to
select the Auto or Normal
trigger mode. To select the
single trigger mode, press
the Single key.
To Next Page
Loading...
