GW Instek GDS-200 Series - Page 162

GDS-200 & GDS-300 Series User Manual
162
Example
Source template
Template
Template
offset from
source
ground
Edit window
Steps
1. From the EE Apps tray select the Template
Editor icon.
2. Select “Draw New Template” or “Load
template from…”.
Draw New Template
Draw a template freehand
Load Template
from…
Uses a previously saved
waveform as a template
3. Select a source channel and press Next.
4. If “Draw New Template” was selected, simply
trace a template (from left to right) on the
screen using the source as guide. The template
will be created from a number of points.
 Press Clear to redo the template drawing.
 Press Undo to delete the last trace point.
 After the points have been drawn,
touching any point on the screen will
return the vertical value.
Press Next when the template is drawn.
5. After the template is first drawn/loaded, the
template offset can be edited by swiping the
screen up or down from the left of the graticule.
6. To edit the template further, swipe the screen