GW Instek GDS-820 - Page 56

GDS-806/810/820/840 Programming Manual
55
:TEMPlate:TOLerance (Available for firmware 2.0 and above only)
Sets and query the tolerance of auto template.
Syntax
:TEMPlate:TOLerance <NR2>
:TEMPlate:TOLerance?
Arguments
<NR2> is the desired tolerance percentage. The range is from 0.4~40 (0.4% to
40%).
Returns
<NR2> %
TIMebase:DELay
Sets the horizontal position (delay timebase) parameter.
Syntax
:TIMebase:DELay <NR3>
:TIMebase:DELay?
Arguments
<NR3> is the desired delay time.
Returns
<NR3>