GW Instek GDS-820 - Page 55

GDS-806/810/820/840 Programming Manual
54
:TEMPlate:POSition:MAX (Available for firmware 2.0 and above only)
Sets and query the position of maximum template. This command will not change
the position value that stored in flash ROM. Unless you press the “Save & Create”
key in GO/NO-GO edit menu. That means if you exit from the GO/NO-GO
function, we will recall the value from flash ROM.
Syntax
:TEMPlate:POSition:MAX <NR2>
:TEMPlate:POSition:MAX?
Arguments
<NR2> is the desired template position. The range is from -12.0 ~ +12.0 div.
Returns
<NR2>
Note: 1 division = 25 dots
:TEMPlate:POSition:MIN (Available for firmware 2.0 and above only)
Sets and query the position of minimum template. This command will not change
the position value that stored in flash ROM. Unless you press the “Save & Create”
key in GO/NO-GO edit menu. That means if you exit from the GO/NO-GO
function, we will recall the value from flash ROM.
Syntax
:TEMPlate:POSition:MIN <NR2>
:TEMPlate:POSition:MIN?
Arguments
<NR2> is the desired template position. The range is from -12.0 ~ +12.0 div.
Returns
<NR2> Div
Note: 1 division = 25 dots