GW Instek GDS-820 - Page 70

GDS-806/810/820/840 Programming Manual
69
:WMEMory<X>:DISPlay
Select whether the stored waveform will be displayed after being saved.
Syntax
:WMEMory<X>:DISPlay <NR1>
:WMEMory<X>:DISPlay?
Arguments
<X>→Specify the location of RefA or RefB memory (1|2)
0→OFF
1→ON
Returns
<NR1>
:WMEMory<X>:ERASe
Select whether the stored waveform will be erased after being saved.
Syntax
:WMEMory<X>:ERASe
Arguments
<X>→Specify the location of RefA or RefB memory (1|2)
:WMEMory<X>:LOCate
Set the position of stored waveform.
Syntax
:WMEMory<X>:LOCate <NR1>
Arguments
<X>→Specify the location of RefA or RefB memory (1|2)
<NR1> is the desired position. The rage is from –200 to +200.