GW Instek GOS-620FG - Technical Specifications; Oscilloscope Vertical Axis Specifications

PECIFICATIONS
GOS-620FG 20MHz OSCILLOSCOPE + FUNCTION GENERATOR
,OSCILLOSCOPE
lsensitivitv 15m~ - 5VIDIV. 10 stem in 1-2-5 seauence
- -~~- - ~
Sensitivity Accuracy
53%
( x 5 MAG : 55%).
Vernier Vertical sensitivity To 112.5 or less of panel-indicated value.
DC-20MHz
( x 5MAG: DC-7MHz).
'ERTICAL
AXIS
Frequency bandwidth
AC coupling: Low limit frequency of 10Hz.
(With reference to IOOkHz, 8DIV. Frequency response at -3dB).
Rise time
Approx. 17.5nS (x5 MAG: Approx. 50nS).
Input impedance
Approx. 1M ohm 11 Approx. 25pF.
Square Wave
Overshoot
: 5 5% ( At IOmVIDIV range).
Characteristics
Other distortions and other ranges: 5% added to the above value.
DC Balance Shift Panel adjustable.
Linearity
<iO.lDIV of amplitude change when waveform of 2 DIV at graticule center is moved vertically.
CHI
: CHI single channel.
CH2
: CH2 single channel.
Vertical modes
DUAL
: CHI and CH2 are displayed. ALT or CHOP selectable at any sweep rate.
ADD
: CHI + CH2 algebraic addition.
Approx, 2 jOkHHz,
Frequency
Input Coupling AC, GND, DC.
300Vpeak (AC: frequency I kHz or lower).
. .
Maximum Input Voltage
Set probe switch at
1: 1, the maximum effective readout is 4Wpp (14Vrms at Sine wave).
set probe switch at
10: 1, the maximum effective readout is 400Vpp(140Vrms at Sine wave).
common Mode
50:l br better at 56wz sinusoidal wave. (When sensitivities of CHI and CH2 are set equally).
Ratio
Isolation between channels >1000:
1
at 50kHz.
(At 5mVIDIV range) >30:
1 at 20MHz.
CHI signal output
At least 20 mvldiv into a 50Rterminal. Bandwidth is 50Hz to 5MHz at least.
CH2 TNV BAL.
Balanced point variation: 51 DIV (Reference at center graticule).
-3-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com