GW Instek GPD-3303S - Setup Procedures; Power Up Procedure

SETUP
SETUP
This chapter describes how to properly power up
and configure the GPD-X303S series before
operation.
Power Up
Select AC voltage
Before powering up the power
supply, select the AC input
voltage from the rear panel.
Connect AC
power cord
Connect the AC power cord to
the rear panel socket.
Power On
Press the Power switch to turn
on the power. The display shows
the initialization screen with the
model name (3303S shown),
followed by the last recalled
settings.
Power Off
Press the Power switch again to turn off the power.
23