GPD-X303S Series User Manual
Remote Connection Step
Entering the
remote control
mode
1. Connect the USB cable to the slave port.
2. The connection will be automatically
established, and the front panel shows a
“USB…YES” message.
3. The power supply front panel is automatically
locked (the Lock key will become activated).
Leaving the
remote control
mode
1. To exit remote mode either, 1) use the LOCAL
command from the terminal connection, or 2)
Press the LOCK key on the front panel to return
to local mode, or 3) disconnect the USB cable
from the rear panel.
2. The display shows “USB…NO” message.
3. The LOCK will no longer be lit when remote
mode is off.
44
To Next Page
Loading...
