REMOTE CONTROL
REMOTE CONTROL
Remote Control Setup
Background
The GPD-X303S is capable of being remotely
controlled via a USB connection.
Interface
USB slave port, rear panel
COM setting
Set up the COM port inside the PC according to
the following list.
• Baud rate: 9600/57600 /115200
• Parity bit: None
• Data bit: 8
• Stop bit: 1
• Data flow control: None
Functionality
check
Run this query command via the terminal
application such as MTTTY (Multi-threaded TTY).
*IDN?
This should return the identification information:
Manufacturer, model name, serial number,
firmware version.
GW INSTEK, GPD-x303S, SN: xxxxxxxx, Vx.xx
43
To Next Page
Loading...
