SETUP
Output On/Off
Panel operation
Pressing the Output key turns
on all channel outputs.
The key LED also turns on. Pressing the Output
key again turns the output and the key LED off.
Automatic output
off
Any of the following actions during output on
automatically turns it off.
• Change the operation mode between
independent / tracking series / tracking parallel
• Recalling other setups from the memory
• Storing the setup into the memory
Beep On/Off
Panel operation
By default, the beep sound is
enabled. To turn off the beep,
press the CH2 or CH2/CH4 key
for 2 seconds.
A beep will be heard and the beep setting will be
turned off. To enable the beep, press the CH2 or
CH2/CH4 key again for 2 seconds.
List of beep
The following operations beep when the beep
setting is on.
• Power on
• INDEP – SER – PARA
mode switching
• Setup save/recall
• Voltage/current knob
fine/coarse switching
To Next Page
Loading...
