PSP Series User Manual
52
Setting for different command format
UART setting can be used to deter if command
format to be modified for the PSP with firmware
V1.66 or above.
Before setting, please make sure that the
connection between a computer and the PSP is
normal by entering “L” from terminal (2400/ N8/
1 or 9600/ N/ 8/1) and get the response message
as shown in the diagram below.
Please complete the settings within 15 seconds
after power is on because setting can’t be changed
after 15 seconds.
The setting procedure only needs to be executed
once. Afterward, the device will be kept in the
same setting mode when the device is turned on
every time.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
