Need help?Do you have a question about the GW Instek PSW 80-27 and is the answer not in the manual?
General| Model | PSW 80-27 |
|---|---|
| Output Power | 2160 W |
| Output Voltage | 0 - 80 V |
| Output Current | 0 - 27 A |
| Voltage Resolution | 10 mV |
| Load Regulation (CV) | ≤ 0.01% + 5 mV |
| Line Regulation (CV) | ≤ 0.01% + 5 mV |
| Protections | OVP, OCP, OTP |
| Operating Temperature | 0°C to 40°C |
| Type | Programmable DC Power Supply |
| Current Accuracy | ±0.1% + 10mA |
| Ripple & Noise (CV) | 10 mVrms |
| Interface | USB, LAN, GPIB (optional) |
| Display | 4.3" TFT LCD |
| Storage Temperature | 70°C |
Provides an overview of the PSW series, including model types and power capacities.
Lists standard and optional accessories available for the PSW series.
Details the physical appearance, including front and rear panels of the PSW units.
Explains the fundamental principles of operation, protection modes, and considerations.
Guides through initial setup procedures like line voltage connection and filter installation.
Covers essential operations like setting OVP/OCP, CV/CC modes, and panel lock.
Explains how to operate multiple units in parallel or series configurations.
Details how to use the Test function for automated testing with scripts.
Details settings like output delay times and slew rate selections.
Explains configuration for USB, GPIB, and RS232 interfaces.
Guides on configuring network settings like IP address and DHCP.
Details settings that can only be configured during power up.
Introduces analog control options for output and power switch.
Details the standard 26-pin Mil connector for analog remote control.
Provides detailed technical specifications for the PSW series units.
To Next Page