Need help?Do you have a question about the GW Instek PSW 30-72 and is the answer not in the manual?
General| Model | PSW 30-72 |
|---|---|
| Voltage Resolution | 10 mV |
| Current Resolution | 1 mA |
| Load Regulation (CV) | ≤ 0.01% + 2 mV |
| Line Regulation (CV) | ≤ 0.01% + 2 mV |
| Protection Features | OVP, OCP, OTP |
| Cooling | Forced air cooling |
| Operating Temperature | 0°C to 40°C |
| Type | Programmable DC Power Supply |
| Output Current | 0-72 A |
| Voltage Accuracy | ≤ 0.05% + 10 mV |
| Current Accuracy | 0.1% + 20mA |
| Programming Interface | RS-232 |
| Storage Temperature | -20°C to 70°C |
| Relative Humidity | ≤ 80% RH (Non-condensing) |
| Input Voltage | 100 - 240 VAC |
Explains symbols used in the manual for safety.
Explains basic principles of operation, operating areas, CC/CV modes, slew rate, and bleeder control.
Guides on connecting the power supply, filter installation, and power up procedures.
Covers essential operations like setting OVP/OCP, CV/CC modes, display modes, and panel lock.
Explains how to connect and operate units in parallel or series using Master-Slave configuration.
Explains settings for output delay, slew rates, V-I mode, bleeder control, buzzer, and lock mode.
Settings applied during power-up for initial operation, like CV/CC control, power-on output, and master/slave modes.
How to control output voltage using an external voltage source via the analog connector.
How to control output current using an external voltage source via the analog connector.
How to control output voltage using an external resistance via the analog connector.
How to control output current using an external resistance via the analog connector.
Provides detailed technical specifications for various PSW models across different types.
To Next Page
