ANALOG CONTROL
135
When using a switch over long distances, please
use a switch relay to extend the line from the coil
side of the relay.
Switch
Relay
Line
extention
Analog
connector
Output
Terminal
12
2
If a single switch control is to be used for multiple
units, please isolate each instrument. This can be
achieved by using a relay.
Ensure the cables and switch used exceed the
isolation voltage of the power supply. For example:
insulation tubes with a withstand voltage higher
than the power supply can be used.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
