GW Instek PSW 80-27 - Page 91

OPERATION
91
2. Turn on the power. MS (Mass Storage) will be
displayed on the screen after a few seconds if
the USB drive is recognized.
Note
If the USB drive is not recognized, check to see
that the function settings for F-20 = 1 (page 110). If
not, reinsert the USB flash drive.
3. Configure T-02 (Test Load) to 1~10
(save memory slot)
Page 89
T-02 range
1~10 (t001 ~t010)
4. The script will now be available in the memory
slot the script was saved to.
Note
Error messages: If you load a file that is not
present on the USB drive “Err 002” will be
displayed on the display.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com