GW Instek SPS-1230 - Page 20

SPS Power Supply User Manual
20
Note
Over volta
g
e protection is alwa
y
s on and cannot be
disabled. The OVP voltage however, can be set to
the rating voltage +5.5%.
Load Cable Connection
Standard
accessory
Insert the plug into the
socket.
Test lead
1. Turn the terminal
counterclockwise and
loose the screw.
2. Insert the cable
terminal.
2
1
3. Turn the terminal
clockwise and tighten
the screw.
3
Banana plug
Insert the plug into the
socket.
Wire type
When using load cables other than the attached,
make sure they have enough current capacity for
minimizing cable loss and load line impedance.
Use the table below to choose an adequate test lead
for a given application.