SAFETY INSTRUCTION
5
Do not dispose electronic equipment as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased.
Safety Guidelines
General Guideline
CAUTION
x Do not place heavy objects on the power supply.
x Avoid severe impact or rough handling that
may damage the power supply.
x Avoid discharges of static electricity on or near
the power supply.
x Use only mating connectors, not bare wires, for
the terminals.
x Do not block the cooling fan vent.
x The power supply should only be disassembled
by a qualified technician.
(Measurement categories) EN 61010-1:2001 specifies the
measurement categories and their requirements as follows. The SPS
falls under category II.
x Measurement category IV is for measurement performed at the
source of a low-voltage installation.
x Measurement category III is for measurement performed in a
building installation.
x Measurement category II is for measurement performed on
circuits directly connected to a low voltage installation.
x Measurement category I is for measurements performed on
circuits not directly connected to Mains.
Power Supply
WARNING
x AC Input voltage: 115V / 230V ±15%
x 47 ~ 63Hz
x Connect the protective grounding conductor of
the AC power cord to an earth ground
To Next Page
Loading...
Need help?
General
