SPS Power Supply User Manual
22
Setting the Current Level
The current level must be set each time a new
current level is needed.
Panel operation
1. Determine the maximum safe current for the
EUT.
2. Short the positive (+) and
negative (-) terminals.
3. Turn the coarse voltage
knob away from the zero
position until the C.C.
knob becomes lit.
4. Adjust the current knobs
to the desired current
limit. The current will be
shown in the ammeter
display.
5. The current limit has now been preset. Do not
change the current values.
6. Remove the short from
the terminals.
a9a$
*1'
7. The power supply is now ready for constant
voltage operation.
To Next Page
Loading...
