14
STARTIUM 330E / 480E / 680E / 980E
EN
Translation of the original instructions
• Clean the device’s surfaces with a soft, dry cloth.
Regulations
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
GENERAL DESCRIPTION
The STARTIUM range is designed to charge and start all common batteries including lead-acid , electrolyte or gel
batteries, 12V et 24V.
Assembling the handle and the wheels (only for 480E, 680E and 980E) :
POWER SUPPLY
Check that the power supply and its protection (fuses) are compatible with the current required by the machine. The
device must be positioned so that the socket is easily accessible. The machine must be connected to a socket WITH
earth according to the following recommendations:
STARTIUM 330E STARTIUM 480E STARTIUM 680E STARTIUM 980E
Mains voltage 230V - 1 ph 230V - 1 ph 230V - 1 ph 230V - 1 ph
Protection 16 A 16 A 16 A 16 A*
Charging
power
charge
800 W 1 700 W 2 000 W 2 000 W
Starting
6 500 W 9 000 W 10 000 W 12 000 W
*In the event that starting a HGV proves difcult , use a 20A plug (optional).
The recommended cross-section for an extension is : 3 x 2,5 mm².
CONNECTION AND DISCONNECTION (cf p.5)
Before any connection
• Before any connection to a vehicle battery, make sure
that the booster isn’t connected to the mains and that the
booster’s switch is set to OFF.
• Locate the + and - battery terminals. (polarity reversal can
damage the fuse).
• Keep the cables away from hot or sharp surfaces. Separate
the 2 cables properly and avoid pinching them.
• Check that the battery capacity (Ampere hour Ah) and
the voltage (Volt V)are compatible with your charger (see
table above).
To Next Page
Loading...
