CLEANUP CYCLE
Cleanup Cycle Duration is not always enabled, so it may not appear. When it is available, set the
length of time the heat/filter pump will run after each use. 0-4 hours are available. Setting to 0.0 Hr
prevents the Cleanup Cycles from running.
The Cleanup Icon
on the Settings Screen takes you to the Cleanup Cycle screen.
Note: Cleanup cycles do not apply to systems set for 24hr circulation pump mode as the circulation
pump performs as the heat and filter pump to provide constant filtration.
LANGUAGE
The Language Icon
on the Settings Screen takes you to the Language screen.
Change the language displayed on the panel.
To Next Page
Loading...