H3C MSR 900 Series User Manual

4-8
Configuring SNMP v3
Select System Management > SNMP from the navigation tree to
enter the page shown in
Figure 4-8.
Figure 4-8 SNMP v3 configuration page
z Select the radio button before Enable to enable SNMP.
z Select the radio button before SNMPv3 to specify the SNMP
version.
z Enter the information of the manufacturer in the Contact
Information field to ensure that the information is available when
needed.
z Configure the system name in the Sysname field. The system
name will be displayed in the upper left of the navigation bar.
z Enter the location of the device in the Device Location field so
as to facilitate location of faulty devices during troubleshooting.

H3C MSR 900 Series Specifications

General

Brand	H3C
Model	MSR 900 Series
Category	Network Router
Language	English