25
Use timer quiet to set the quiet time for a POS application template.
Use undo timer quiet to restore the default.
Syntax
timer quiet interval
undo timer quiet
Default
The quiet time is 600 minutes.
Views
POS application template view
Predefined user roles
network-admin
Parameters
interval: Specifies the quiet time for the POS application template, in the range of 10 to 600 minutes.
Usage guidelines
When a POS terminal launches a transaction, the router tries to establish a TCP connection with the FEP.
If the FEP is unreachable, the router places the FEP to blocked state and starts the quiet timer.
The configuration takes effect immediately and the quiet timer restarts at 0.
Examples
# Set the quiet timer for POS application template 1 to 500 minutes.
<Sysname> system-view
[Sysname] posa app 1 type tcp
[Sysname-posa-app1] timer quiet 500
Related commands
backup app
tpdu-change
Use tpdu-change to configure the TPDU address change policy. The router uses the policy to change
either the TPDU originator or destination addresses of packets before sending them to FEPs.
Use undo tpdu-change to remove the configuration.
Syntax
tpdu-change { destination | source }
undo tpdu-change
Default
The router changes the TPDU originator address.
Views
POS application template view
To Next Page
Loading...
Need help?
General
